jing_902@163.com

Home   |   Door Access Control

Door Access Control

  • Waterproof  Access Control System Door Keypads
  • Waterproof  Access Control System Door Keypads
  • Waterproof  Access Control System Door Keypads
  • Waterproof  Access Control System Door Keypads
Waterproof  Access Control System Door KeypadsWaterproof  Access Control System Door KeypadsWaterproof  Access Control System Door KeypadsWaterproof  Access Control System Door Keypads

Waterproof Access Control System Door Keypads

  • Model Number: S006
  • User Capacity: 1000
  • Proximity Card Reader EM or HID & EM
  • Product Name Waterproof Standalone Access Control With Keypads
  • INQUIRY
Product Descripition

Introduction

The S006 is a single door multifunction standalone Access Controller or a Wiegand output reader. It uses Atmel
MCU assuring stable performance. The operation is very user-friendly, and low-power circuit makes it long
service life.
The S006 supports 1,000 users (998 common users + 2 panic users), all user data can be transferred from one
to another (Max 10pcs). It supports multi access modes in either card access, PIN access, Card + PIN access,
or multi cards/PINs access. It has extra features including block enrollment, interlocked, Wiegand 26~37 bits
interface…etc.


Specification
Product Name
Waterproof Standalone Access Control With Keypads
User Capacity
1000 Users
Proximity Card Reader
EM or HID & EM
Waterproof degree
IP66
Wiegand Interface
Wiegand 26-37 bits
Operating Voltage
12~24V AC/DC

Features


Waterproof, conforms to IP66

One relay, keyboard programmer

1,000 users (998 common users + 2 panic users)

PIN length: 4~6 digits

Card type: 125KHz EM card,  HID and EM cards

Wiegand 26~37 bits input & output

Can be used as Wiegand reader with LED & buzzer output

Card block enrolment

Tri-colour LED status display

Integrated alarm & buzzer output

Pulse mode, Toggle mode

User data can be transferred

2 devices can be interlocked for 2 doors

Built in light dependent resistor (LDR) for anti tamper

Backlit keypad

Low temperature resistance(-40℃)


Installation

Remove the back cover from the unit

Drill 2 holes(A,C) on the wall for the screws and one hole for the cable

Knock the supplied rubber bungs to the screw holes(A,C)

Fix the back cover firmly on the wall with 4 flat head screws

Thread the cable through the cable hole(B)

Attach the unit to the back cover



Wiring Diagram


Scan the qr codeClose
the qr code